 |
| |||
|
Google this page is not a duplicate Connect a Wireless Netgear DG834G Modem Router Do not use the disk for installation, I have done this many times and never needed the disk Connect to the ADSL Filter and with the phone/modem wire Turn the Netgear on Connect the Network Ethernet cable, usually, grey, blue, black or yellow from the Computer to one of the ports of the back of the router number 1 to 4 the number light at the front comes on when connected Click Start --> Control Panel --> Network Connections In Vista you need to also go into Manage Network Connections Double Click on your Local Area Connection, then click Support to see the Local Area IP Address and Default Gateway Note down the Default Gateway Now Open Internet Explorer Ignore any page not found error At the top where you would enter a website address, enter https://"put your default gateway address here" e.g https://192.168.0.1 or https://192.168.1.1 In the pop-up enter the username and password, these are not your broadband username and password Sometimes these values are on the underside of the Netgear or try "admin" for the username and "password" for the password Now use the "setup Wizard" to configure entering the Broadband username and password when asked to in the "Basic Settings" page Under Wireless settings you can also set up your Wireless Network name (SSID) and your WEP or WPA key WEP is always only hexadecimal characters i.e 0-9 and A-F only WPA lets you use a word and numbers IP | ||||
|
||||